RM0209 ATX 4U Rackmount Chassis Sliding Rail Installation Sheet

1. Remove the decorative side panels from RM0209 Chassis. There is one on each side of the chassis.

2. There should be 10 mounting holes on each side of the RM0209 Chassis. Only two mounting holes are useful for mounting the sliding rail.

3. Disassemble the sliding rail by extracting the inner part of the slide from the outer part of the slide. Press the locking clip inside the sliding rail to pull out the inner part of the slide.

4. Match the mounting-hole number 3 on the inner slide to mounting-hole number 2 on the RM0209 Chassis. See the picture below.

5. Match the mounting-hole number 5 on the inner slide to mounting-hole number 5 on the RM0209 Chassis. See the picture below.

6. Use the type “A” screws to secure the inner slide on to the side of the chassis.

7. Finish.